Anonymity is a Roadblock - Full Disclosure is a Portal
SITE CURRENTLY BEING MODIFIED AS EXPLANATORY INFORMATION IS ADDED.

From Open Lives

This is text using tab 0.
But simple page edit enables the same thing.

However this line was done with the new edit section 0 tab which is better than displaying the whole document for editing and better than the tab 0 because it is consistent with the other section edit tabs. Note that there is no reply because replies to section 0 do not make sense.
--Paul Antonik Wakfer 07:14, 29 March 2009 (UTC)

Meta page of Entry Page Discussion of Content Page -- Paul Antonik Wakfer 08:11, 21 March 2009 (UTC)

This the page of overview of the discussion of the Entry Page.

Removed signature at end of this new thread.

New Section on Entry Page --Paul Antonik Wakfer 01:43, 27 March 2009 (UTC)

This is a new Entry Page section.

Re: New Section on Entry Page --Paul Antonik Wakfer 05:12, 30 March 2009 (UTC)

One more time to see if reply to only one section will work, after previewing and writing back.

Re: New Section on Entry Page --Paul Antonik Wakfer 02:28, 31 March 2009 (UTC)

This is a subsection to see about edit of it alone.

Edit to level 3 section before testing a reply to it.

Re: New Section on Entry Page --Paul Antonik Wakfer 05:20, 31 March 2009 (UTC)

--Paul Antonik Wakfer 05:14, 30 March 2009 (UTC) wrote:

This is a subsection to see about edit of it alone.

This is the reply to this first correctly formatted inline reply mode thread.
Note that I do not need to leave any blank lines when I input, but they will be there in preview or save because the indent always creates blank lines around itself.

Edit to level 3 section before testing a reply to it.

This is a reply to the next paragraph about edit to level section 3 before testing.

Re: New Section on Entry Page --Paul Antonik Wakfer 05:34, 31 March 2009 (UTC)

--Paul Antonik Wakfer 05:14, 30 March 2009 (UTC) wrote:

--Paul Antonik Wakfer 05:14, 30 March 2009 (UTC) wrote:

This is a subsection to see about edit of it alone.

This is the reply to this first correctly formatted inline reply mode thread.

I can reply to this first line.

Note that I do not need to leave any blank lines when I input,

And I can break a line to reply to part of it.

but they will be there in preview or save because the indent always creates blank lines around itself.

and then reply to the next part (after first adding ":" indent marks at the start of it.

Edit to level 3 section before testing a reply to it.

This is a reply to the next paragraph about edit to level section 3 before testing.

This is a final reply to the last line of the message.
Note that no blank lines were used when composing this reply

Re: New Section on Entry Page --Paul Antonik Wakfer 05:14, 30 March 2009 (UTC)

This is a reply to level 3 section with second edit line.

Since it is a reply to a level 3 heading, it becomes a level 4 heading.

Re: New Section on Entry Page --Paul Antonik Wakfer 03:06, 31 March 2009 (UTC)

This is a reply to level 3 section with second edit line.

And this is a reply to that reply, which I have purposefully left with no blank lines.

Since it is a reply to a level 3 heading, it becomes a level 4 heading.

But with another reply it becomes level 5.

Re: New Section on Entry Page --Paul Antonik Wakfer 02:34, 31 March 2009 (UTC)

Should generate a table of contents because was 4 page heading. Leaving a space prefix will cause a quote to be generated.

This is a new line generate by use of a break instead of a blank line.

New section on Entry Discussion page --Paul Antonik Wakfer 02:30, 31 March 2009 (UTC)

This is the text of the new section, which would be the start of a new thread.

Try another new section without putting in a headline.

Test of New Thread --Paul Antonik Wakfer 17:38, 31 March 2009 (UTC)

This is the text of the new thread about the article page subject.

I have lots and lots to say about the interesting subject of article page that this discussion page relates to page.